MANUFACTURE AND VALIDATION OF SLURRY EROSION TEST MACHINE

Authors

  • Amado Cruz-Crespo Centro de Investigaciones de Soldadura (CIS), Facultad de Ingeniería Mecánica e Industrial. Universidad Central “Marta Abreu” de Las Villas, Carretera a Camajuaní, km 5 ½, Santa Clara, Villa Clara, Cuba.
  • Evit Rodríguez Acosta Empresa Planta Mecánica “Fabric Aguilar Noriega”, Calle A no. 39 e/c, Arroyo Carrascal y Carretera a Planta Mecánica, Zona Industrial Noroeste, Ciudad de Santa Clara, Villa Clara, Cuba.
  • Tamara Ortiz Méndez entro de Investigaciones de Soldadura (CIS), Facultad de Ingeniería Mecánica e Industrial. Universidad Central “Marta Abreu” de Las Villas, Carretera a Camajuaní, km 5 ½, Santa Clara, Villa Clara, Cuba
  • Eduardo Díaz-Cedré abricación y Tecnología en Soldadura S.A de C.V, Campesinos No 7, Col Peñuelas, Querétaro, México
  • Alejando Duffus Scott Centro de Investigaciones de Soldadura (CIS), Facultad de Ingeniería Mecánica e Industrial. Universidad Central “Marta Abreu” de Las Villas, Carretera a Camajuaní, km 5 ½, Santa Clara, Villa Clara, Cuba.
  • Rodolfo Najarro Quintero Departamento, Facultad, Universidad Técnica de Cotopaxi, Av. Los Almendros y calle Pujili sector La Virgen, La Maná - Ecuador

Keywords:

wet erosion, recharge, arc manual welding

Abstract

This paper describes the manufacture and validation of a wet erosion testing machine. Based in norms for the erosive test and non-standardized machines reported in scientific publications analysis, a machine that responds to research and teaching needs is development. For test equipment design was considered that manufacturing cost was low and its technological simplicity in order to make manufacturing viable. A variable speed stirrer with a tool holder for coupling the sample holder was used on the manufacture of this machine. This sample holder device allows two samples of trapezoidal configuration simultaneous testing. The machine was validated by testing, under sample holder different rotational speeds. Samples of an extractor blade and samples of coatings, obtained by manual welding with a coated electrode of recharge, were tested.

Downloads

Download data is not yet available.

Downloads

Published

2019-04-01

How to Cite

Cruz-Crespo, A., Rodríguez Acosta, E., Ortiz Méndez, T., Díaz-Cedré, E., Duffus Scott, A., & Najarro Quintero, R. (2019). MANUFACTURE AND VALIDATION OF SLURRY EROSION TEST MACHINE. Centro Azúcar Journal, 46(2), 9. Retrieved from http://centroazucar.uclv.edu.cu/index.php/centro_azucar/article/view/33

Issue

Vol. 46 No. 2 (2019)

Section

Original Articles

Most read articles by the same author(s)

1 2 > >>